Canning/Processing Information

Moderator: Axe

Post Reply
Beckberg
Posts: 24
Joined: Thu Sep 13, 2012 4:13 pm

Canning/Processing Information

Post by Beckberg » Wed Sep 26, 2012 12:01 pm

For everyone who is interesting in saving Summer's and Fall harvest here is some helpful information you may want to read...


You don’t need a lot of special equipment for canning not even one of those purpose-built blue-speckled canners. Use any lidded pot that’s at least 3″ (7.5 cm) taller than your jars. Other canning must-haves include basic kitchen utensils and a few specialty tools:

•Glass Mason jars with two-piece, self-sealing lids (a flat sealing disc with a rubber gasket, and a metal screw band). Wash new jars and sealing discs. You can reuse jars and screw bands if they’re in good condition; sealing discs, however, should be used only once.
•A wire rack to keep jars off the bottom of the pot. They’re sold with canning supplies, but a small baking rack, a metal trivet, or even screw bands tied together with twine will do the trick.
•A jar lifter or heat-resistant, waterproof silicone gloves for getting hot jars into and out of the pot.
•A timer, a slotted spoon or tongs, a ladle, a plastic knife for removing air bubbles, and labels for the jars. A wide-mouth funnel and a magnetized “wand” (to retrieve sealing discs from hot water) are both helpful but not essential.
Canning basics
The steps below don’t apply to all canning recipes; you can safely use the boiling-water method for the recipes on these pages, which are acidic enough to inhibit harmful bacteria. Low-acid recipes need special methods and equipment, including a pressure canner.
Feel free to adjust spices and salt to taste, but tinkering with other ingredients and quantities could reduce acidity. (In that case, refrigerate the food instead of processing it, and eat it within a month.)

Before you start
1.Organize your tools. Because jar size affects process-ing time, use the size specified. Fill canning pot two-thirds full with cold water.
2.For recipes that are quickly prepared, put the pot on high heat immediately; otherwise, begin heating the water about 30 minutes before you finish the food prep. Once the water comes to a full boil, reduce heat to low. Place clean jars upright on the rack in the pot, partly submerged in hot water, and cover pot. For these recipes, sterilizing jars before filling isn’t required, since they’ll be processed for at least 10 minutes. But the old canning adage, “Hot food into hot jars, and hot jars into hot water,” still applies. “Hot” is simmering, not boiling: 180°F (82°C).
3.Heat a kettle of water, in case you need more to cover the filled jars.

Filling the jars
1.When the food is ready for the jars, put the sealing discs in a heatproof bowl and ladle hot water over them to soften the rubber gaskets.
2.Using a jar lifter or silicone gloves, lift a jar, pouring the water inside the jar back into the pot. Fill jar with hot food, following the recipe directions. A wide-mouth funnel prevents sticky spills. Leave 1/4″ (0.5 cm) headspace between top of food and jar rim in 250 ml jars, and 1/2″ (1 cm) in 500 ml jars. If you end up with a partially filled jar, simply refrigerate and use within a month.
3.Remove trapped air bubbles by slowly running a plastic knife (or a canning de-bubbler tool) around jar wall. Wipe rim clean.
4.Using gloved fingers or magnetized lid wand, place a warm sealing disc on jar. Add screw band, twisting until finger tight. (Overtightening bands prevents jars from venting and can lead to seal failure.)
5.After filling each jar, place on rack in pot, leaving 1/2″ (1 cm) between jars. When pot is full, add more hot water if needed to cover jars by 1″–2″ (2.5-5 cm). Cover pot with lid. (If all the jars won’t fit, keep remaining food hot while one batch is processing, then fill and process the rest of the jars.)

Processing
1.Bring pot with filled jars to a boil on high heat. When water reaches a full boil, set your timer for processing time in the recipe. Add 5 minutes for elevations above 1,000 ft. (306 m); 10 minutes for 3,000–6,000 ft. (915–1,830 m). Maintain a gentle boil for entire processing period. When timer rings, turn off heat, take off pot lid, and leave jars in pot for 5 minutes to settle.
2.Using a jar lifter or silicone gloves, place jars on a tea towel to cool, away from drafts. Leave upright and undisturbed for 12 hours.
3.When jars are cool, press on the disc; if it springs back after you remove your finger, the seal has failed. Refrigerate and use within a month.
4.Label and date each jar, store in a cool, dark place, and enjoy your preserves within a year.
Last edited by Beckberg on Wed Sep 26, 2012 2:11 pm, edited 1 time in total.

Bergy
Posts: 22468
Joined: Mon Sep 12, 2011 9:53 am

Re: Canning/Processing Information

Post by Bergy » Wed Sep 26, 2012 1:50 pm

Great info Thanks - I don't can any more except for a jar or two here and there - but this very helpful especially for starting canners

Shadows1
Posts: 7215
Joined: Tue Aug 14, 2012 3:41 pm

Re: Canning/Processing Information

Post by Shadows1 » Wed Sep 26, 2012 2:04 pm

Also you can contact your local university extention service for their publications on canning and pickling, most are free for the asking and have all the latest saftety info in them.

Your above info is indeed helpful.

Beckberg
Posts: 24
Joined: Thu Sep 13, 2012 4:13 pm

Re: Canning/Processing Information

Post by Beckberg » Wed Sep 26, 2012 2:12 pm

thanks Bergy and Shadows1! :)

Dissie
Posts: 9065
Joined: Thu Oct 13, 2011 12:15 pm

Re: Canning/Processing Information

Post by Dissie » Sun Nov 04, 2012 11:51 pm

Great information!

Post Reply